The Anycubic Wash & Cure 3 has an impressive 100% increase in cleaning basket capacity over the Anycubic Wash & Cure 2.0, which is now 3 liters. The cleaning bucket now has a total capacity of 4 liters. This makes it ideal for LCD (light-curing) 3D printers that are 7.3 inches or smaller in size. To accommodate larger and more models for a single post-processing session, the curing size has increased by 15%, to 160*180 millimeters.
The energy value is increased by 30,000uW/cm2 within a 1-3 cm irradiation range by the “Innovative Flexicure Gooseneck Light Design,” significantly enhancing the curing effect on delicate areas like the tops of models and the hems of clothing.
Anycubic Wash & Cure 3’s curing uniformity has increased by 20% compared to its predecessor 2.0 by using a completely new arrangement of light beads and a lens light source. As a result, the entire model is more thoroughly and completely cured.
The platform and the double-layered cleaning basket made of PP material are intended to be cleaned simultaneously. With two height adjustments at 100mm and 165mm, it can accommodate printing platforms with a width of 5.9 inches to 7.3 inches. The effectiveness of IPA usage is maximized by this design.
Dual cleaning and curing modes are simply switched between with a single click; the enhanced gooseneck light curing mode is simply turned on and off. Unlimited rotary knob control with freely selectable durations of 1 to 30 minutes.